I am new to COMSOL and need some help/advise from someone with experience.
This simulation is modeling a 25% glass filled-teflon billet extrusion through a steel die (1/4 of the entire model). I added a stationary study with laminar conjugate heat transfer with solid mechanics and applied symmetry. The exterior extrusion should have thermal expansion.
I am not sure where the error is, but it can be the actual material properties, boundary assignments, or the mesh. I am trying to plot surface pressure, temperature, velocity and von mises.
This is the error message I get.
Segregated group 1
Out of memory during assembly.
------------------------------------------
Thank you
This simulation is modeling a 25% glass filled-teflon billet extrusion through a steel die (1/4 of the entire model). I added a stationary study with laminar conjugate heat transfer with solid mechanics and applied symmetry. The exterior extrusion should have thermal expansion.
I am not sure where the error is, but it can be the actual material properties, boundary assignments, or the mesh. I am trying to plot surface pressure, temperature, velocity and von mises.
This is the error message I get.
Segregated group 1
Out of memory during assembly.
------------------------------------------
Thank you