Dear all,
I suppose that Comsol example: Electromagnetic forces on parallel current-carrying wires in ACDC_Module/Verification_Models/parallel_wires should be fully and properly working example.
I tried to change currents in wires in Parameters section from 1A to 10, and 100 A and after that I observed that the calculated force was not changed.
Is something else I need to change? Am I doing some mistake?
Comsol version is 4.3.
Thank you in advance,
Jozef.
I suppose that Comsol example: Electromagnetic forces on parallel current-carrying wires in ACDC_Module/Verification_Models/parallel_wires should be fully and properly working example.
I tried to change currents in wires in Parameters section from 1A to 10, and 100 A and after that I observed that the calculated force was not changed.
Is something else I need to change? Am I doing some mistake?
Comsol version is 4.3.
Thank you in advance,
Jozef.